The Toolbox helps you understand the types of equipment used to meter, mix and dispense a wide variety of resin systems.
Additional machine design considerations including material parameters, useful conversion charts, handy formulas and typical application information are provided to further enhance your knowledge of dispensing equipment.
Use the interactive Throughput Calculator software to calculate throughput, amount of material used, estimated material cost, amount of material needed on each part, and mixed specific gravity.
P-200 point-to-point automation platform software to calculate material uses, estimated material cost, amount of material needed on each part, and mixed specific gravity.
C-500 XYZ automation platform software to calculate material uses, estimated material cost, amount of material needed on each part, and mixed specific gravity.
Viscosity is the measurement of a fluid's internal resistance to flow. This is typically
designated in units of centipoise or poise but can be expressed in other acceptable
measurements as well.
Filler is a general term used to describe an organic, non-metallic or metallic powder added to resins. Fillers can extend material for cost reduction and/or enhance the material's mechanical properties.
