CarClad Macropoxy HS

Product Description:

CARCLAD MACROPOXY HS is an epoxy mastic designed for application to properly prepared steel surfaces. It may be used as a one or two coat, direct-to-metal protective coating, or over a Macropoxy primer. It can be applied to marginally prepared surfaces.

Features:

• High build for good coverage on rough corners and edges
• Resistant to a variety of solvents and chemicals
• Corrosion resistant
• Long term durability

PRODUCT CHARACTERISTICS:

Finish: Semi-Gloss, 50+ units @ 60 degrees

Color: Black, Gray, White, and Boxcar Red

Volume Solids: 80% +/- 2% mixed, may vary by color 

VOC (EPA Method 24):  

Unreduced: 241 g/l; 2.0 lb/gal

Reduced (10%): Oxsol 100 Exempt Solvent

Reduced (10%): MEK: 290 g/l; 2.42 lb/gal

Reduced (10%): Reducer #54: 268 g/l; 2.24 lb/gal

HAPS:

Unreduced: 0.91 lbs HAPS / gal Coating Solids Reduced: 0.91 lbs HAPS / gal Coating Solids (Oxsol 100) Reduced: 1.32 lbs HAPS / gal Coating Solids (MEK) Reduced: 1.57 lbs HAPS / g

Mix Ratio: 1:1 by volume

The following is a guide. Changes in pressures and tip sizes may be needed for proper spray characteristics. Always purge spray equipment before use with listed reducer. Any reduction must be compliant with existing VOC regulations and compatible with the existing environmental and application conditions.

Recommended Uses:

• Rail Cars
  
• Tank Cars

*Note: For complete product information, please refer to sherwin-williams.com.